Disa Auto Answer - Panasonic DBS-2.3-400 Programming Manual

Chapter 2. Trunk Programming (FF2)

DISA Auto Answer

Software Version: All Versions
Address: FF2 (Trunk)# 11# (0 or 1)#
Description
Use this feature to set a trunk(s) to automatically provide DISA tone upon
connection with an inbound caller. (However, after hearing the DISA tone,
the caller will still have to enter an ID code in order to use DISA.)
If a trunk is set to provide DISA tone, you can limit DISA operation on that
trunk to a certain number of hours each day, using the DISA Start Time and
DISA End Time addresses.
Programming
Related Programming
Caller ID Automatic DISA: FF1 2# 8# (1-10)# (PhoneNo.)#
Direct Inward System Access (DISA) ID Code: FF1 5# (0000-9999)#
DISA Outbound Call ID Code 1: FF1 6# 1# (0000-9999)#
DISA Outbound Call ID Code 2: FF1 6# 2# (0000-9999)#
DISA Start Time: FF2 (Trunk)# 19# (HHMM)#
DISA End Time: FF2 (Trunk)# 20# (HHMM)#
Notes
Caller ID Interaction. If your DBS system supports Caller ID, do not enable
DISA on any trunk using this address. (Caller ID will automatically enable or
disable DISA to the caller based on the phone number he is calling from.)
DISA Hardware Requirement. An MFR card is required for DISA, so that
the system can interpret DTMF tones entered via the DISA connection.
Page 2-8
FF2 (1-64)# 11# (0 or 1)#
Trunk Number
DBS Manual - Revised April 2000
Section 400-Programming
0=DISA tone is not provided.
1=DISA tone is provided.
DBS-2.3/9.2-400