Analog Transfer Ring Pattern - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Analog Transfer Ring Pattern

Software Version: CPC-AII (all versions) and CPC-B Version 2.11 or higher
Address: FF1 2# 1# 31# (0-6)#
Description
Use this address to choose a distinctive ringing pattern for calls transferred to
analog SLT phones. This setting is typically used for calls transferred to a
modem, or for SLT phones requiring distinctive ringing for transferred calls.
There are 7 different patterns (numbered 0-6) to choose from. The pattern for
each setting depends on the analog connection --
Programming
Table 1-3 Analog Transfer Ring Patterns (vary depending on analog connection)
Address
Setting
0
1
2
3
4
5
6
Related Programming
Analog Transfer Ring Pattern
Terminal Type: FF3 (ExtPort)# 2# (Type)#
Extension Ring Pattern: FF3 (ExtPort)# 39# (0-9)#
DBS-2.3/9.2-400
• an SLT phone connected directly to an AEC card;
• an SLT phone connected to an OPX Adapter; or
• an SLT phone connected to an SLT-A (4-port Adapter).
Ring Pattern (no. of seconds on/off) for SLT phones connected to ...
AEC Card
.5 on / 4 off
1 on / .25 off / 1 on / .25 off
/ 1 on / 2 off
1 on / .25 off / 1 on / 3 off
1 on / 2 off
1 on / 3 off
1 on / 6 off
1 on / 4 off / 1 on / 7 off
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
FF1 2# 1# 31# (0-6)#
Transfer Ring Pattern setting
(see table below)
OPX Adapter
.5 on / 3.5 off
3 on / 1 off
2 on / 2 off
1 on / 2 off
1 on / 3.5 off
1 on / 5 off
1 on / 7 off
(CPC-A 3.21 or higher)
SLT Adapter (SLT-A)
.25 on / .25 off / .25 on / 3.5 off
.25 on / 3.5 off
1 on / 3.5 off
1 on / 3 off
1 on / 7 off
.5 on / 7 off
.25 on / .25 off / .25 on / 7 off
: FF1 2# 1# 22# (0-6)#
Page 1-39