Table of Contents
Advertisement
Section 400-Programming
Inbound DID Dial Numbers
Software Version: CPC-B Version 2.0 only
Address: FF3 (ExtPort)# 35# (0000-9999)#
Description
DID (Direct Inward Dialing) numbers must be assigned to extension ports so
they will ring on the appropriate extensions.
In CPC-B versions prior to 3.1, DID numbers can be set to ring on only one
extension port. Beginning with CPC-B Version 3.1, DID numbers can be set
to ring on multiple extensions (see address FF1 8# 3# for more information).
Programming
AEC Disconnect
Software Version: CPC-A Version 3.3 or higher
Address: FF3 (ExtPort)# 35# (0 or 1)#
Description
The VB-43621A version of the AEC card can be set to provide a positive
disconnect signal. Use this address to enable or disable the AEC disconnect
signal on individual extensions.
If this option is enabled, analog extension ports will send a disconnect signal
(open loop) upon hangup. Sending this signal allows quick disconnection
from third-party voice mail systems.
This feature requires CPC-A 3.3 or higher, or CPC-AII/B 5.0 or higher (the
address for CPC-AII/B is FF3 ExtPort# 46# 0-1#).
Programming
Related Programming
AEC Disconnect Signal Duration (for CPC-A 3.3 or higher): FF1 2# 1#
DBS-2.3/9.2-400
FF3 (1-144)# 35# (0000-9999)#
Extension Port
FF3 (1-72)# 35# (0 or 1)#
Extension Port
23# (0-15)#
DBS Manual - Revised April 2000
Chapter 3. Extension Programming (FF3)
DID Number
0=Disable AEC disconnect signal.
1=Enable AEC disconnect signal.
Page 3-41
Advertisement
Table of Contents
