Section 400-Programming
Onhook Transfer
Software Version: All Versions
Address: FF1 2# 1# 8# (0 or 1)#
Description
This address determines whether a call can be transferred without pressing
the PROG key.
• If Onhook Transfer is enabled (default setting), the user can transfer a call
• If Onhook Transfer is disabled, the user places the call on hold, dials the
Programming
Related Programming
Attendant Transfer Recall Timer for CO Calls: FF1 3# 4# (0-12)#
Extension Transfer Recall Timer for CO Calls: FF1 3# 5# (0-12)#
Attendant Transfer Recall Timer for Intercom Calls: FF1 3# 24# (0-12)#
Extension Transfer Recall Timer for Intercom Calls: FF1 3# 25# (0-12)#
Notes
Call Transfer Limitation With CPC-A. In CPC-A versions, only trunk calls
can be onhook-transferred to other extensions. In CPC-AII and CPC-B, both
trunk and intercom calls can be onhook-transferred.
Transfer Recalls. If a transferred call recalls to an extension and is not
answered, it will automatically transfer to the attendant. Timing for the
attendant transfer is controlled by the Attendant Call Reversion Timer (FF1
3# 10# 0-12#).
VAU Interaction. If a VAU (Voice Announce Unit) is used, enable Onhook
Transfer to allow the VAU to transfer calls.
DBS-2.3/9.2-400
by placing the call on hold, dialing the extension number, and then hanging
up.
extension number, then presses PROG (or "8" if using an SLT or DSLT
phone) and hangs up to transfer the call.
FF1 2# 1# 8# (0 or 1)#
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
0=Onhook Transfer is disabled.
1=Onhook Transfer is enabled.
Page 1-13