Section 400-Programming
ML/MCO Separation
Software Version: CPC-AII (all versions); CPC-B Version 4.0 or higher
Address: FF3 (ExtPort)# 44# (0 or 1)#
Description
Use this address to enable an extension for MCO or ML key usage.
The difference between ML (Multi-Line) and MCO (Multi-Central Office)
has to do with incoming calls. MCO means multiple trunks can be received at
the extension -- if you press a flashing FF key, you will get an incoming trunk
call. Calls from another extension will flash on the "EXT" LED (not through
the FF key).
ML, on the other hand, means you can receive either a trunk call or an
extension call on an FF key, which will flash for either type of call.
If this address is set to ML, each FF key must be individually enabled for ML/
MCO using program address FF5 (ExtPort)# (Key)# (FeatureCode)#.
Programming
Related Programming
FF Key Assignments for Extensions: FF5 (ExtPort)# (Key)# (Feature)#
DBS-2.3/9.2-400
FF3 (1-144)# 44# (0 or 1)#
Extension Port
* MCO is not available in CPC-B Version 2.0 to 3.1.
** ML is not available in CPC-A versions, or in CPC-B Version 1.0.
DBS Manual - Revised April 2000
Chapter 3. Extension Programming (FF3)
0=MCO keys *
1=ML keys **
Note: The default for the Primary
Attendant is "1" (ML keys).
Page 3-53