Multiple Did/Dnis - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Multiple DID/DNIS

Software Version: CPC-B Version 4.0 or higher
Address: FF1 2# 1# 32# (0 or 1)#
Description
Use this address to enable or disable Multiple DID for analog trunks, or
Multiple DID and DNIS for T1 trunks. By default, Multiple DID/DNIS is
disabled.
With Multiple DID/DNIS enabled, one DID or DNIS number can be assigned
to multiple extensions, which will simultaneously ring when an outside caller
dials the DID or DNIS number.
• DID stands for "Direct Inward Dialing." DID can be used only in systems
• DNIS stands for "Dialed Number Identification Service." DNIS is
Programming
Related Programming
Inbound DID Dial Numbers: FF1 8# 3# (0000-9999)# (100-699)#
DID/DNIS (enabling trunks for): FF1 8# 4# 6# (Trunk)# 2# (0-2)#
DNIS Number Setting: FF1 8# 4# 7# (0000-9999)# (10-69 or 100-699)#
DID Flexible Ringing Assignments: FF1 8# 5# (DIDNo.)# (ExtNo.)#
(000000-111111)#
DNIS Flexible Ringing Assignments: FF1 8# 6# (DNISNo.)# (ExtNo.)#
(000000-111111)#
Extension Numbers (assigning to ports): FF3 (ExtPort)# 1# (ExtNo.)#
Page 1-40
using analog trunks exclusively (no other types of trunks are used in the
system). Up to 500 DID numbers can be assigned to extension numbers in
FF1 8# 3# (0000-9999)# (ExtNo.)#.
available only with the T1 Interface. You can use DID and DNIS
simultaneously in a T1 system. Up to 500 DNIS numbers can be assigned
to extension numbers in FF1 8# 4# 7# (0000-9999)# (10-69 or 100-699)#,
in addition to the 500 DID numbers allowed.
FF1 2# 1# 32# (0 or 1)#
DBS Manual - Revised April 2000
Section 400-Programming
0=Disables Multiple DID/DNIS ringing.
1=Enables Multiple DID/DNIS ringing.
DBS-2.3/9.2-400