Panasonic DBS-2.3-400 Programming Manual page 249

2. Trunk Programming (FF2)
Use the FF2 programming addresses in this chapter to set parameters for the
CO trunks of the DBS system.
Most of these FF2 addresses require a trunk number and/or extension port
entry. The acceptable range of trunks/extension ports varies according to the
configuration of your DBS system. In this chapter, the range used for trunks
is 1-64, which is the maximum available number of trunks in a DBS 96 +
DBS 96 system with a CPC-B card. The range used for extension ports is
1-144, which is also the maximum in a DBS 96 + DBS 96 with CPC-B.
For more information, see Section 300-Installation.
This chapter covers the following FF2 program addresses:
FF Key Address
FF2 (Trunk)# 1# (0-1)#
FF2 (Trunk)# 2# (0-1)#
FF2 (Trunk)# 3# (0-1)#
FF2 (Trunk)# 4# thru 9# (0-1)#
FF2 (Trunk)# 10# (1-2)#
FF2 (Trunk)# 11# (0-1)#
FF2 (Trunk)# 12# (ExtPort)#
FF2 (Trunk)# 13# (0-1)#
FF2 (Trunk)# 14# (0-1)#
FF2 (Trunk)# 15# (1-3)#
FF2 (Trunk)# 16# (0-1)#
FF2 (Trunk)# 17# (0-1)#
FF2 (Trunk)# 18# (0-15)#
FF2 (Trunk)# 19# HHMM#
FF2 (Trunk)# 20# HHMM#
FF2 (Trunk)# 21# (0-4)#
FF2 (Trunk)# 22# (0-1)#
FF2 (Trunk)# 23# (0-15)#
FF2 (Trunk)# 24# (0-15)#
FF2 (Trunk)# 25# (0-15)#
FF2 (Trunk)# 26# (4-8)#
DBS-2.3/9.2-400
Topic
Trunk Port Operation
DTMF/Pulse Dialing for Trunks
Pooled Trunk Access for Group "9"
Pooled Trunk Access for Groups "81-86"
Trunk Port Type
DISA Auto Answer
Private Trunk Line
Automatic Pause for PBX Line
Dial Tone Detection
Outbound DTMF Signal Duration for Auto-Dialed
Digits
Unsupervised Trunk Conference
Inbound Ring Pattern
Trunk Disconnect Detection Timer
DISA Start Time
DISA End Time
Trunk Circuit Type
DID Immediate or Wink Start
Wink Start Timer
Time Out for Dialed DID Digits
DID Interdigit Timeout
Trunk Port Class
DBS Manual - Revised April 2000
(CPC-AII/B)
(CPC-B only)
(CPC-B only)
(CPC-B only)
(CPC-B only)
(CPC-B only)
Page
2-3
2-4
2-5
2-6
2-7
2-8
2-9
2-10
2-11
2-12
2-13
2-14
2-15
2-16
2-17
2-18
2-21
2-22
2-23
2-24
2-25
Page 2-1