Hunt Group Members - Panasonic DBS-2.3-400 Programming Manual

Chapter 4. Ringing and Hunt Groups (FF4)

Hunt Group Members

Software Version: CPC-A; CPC-B Versions prior to 2.0
Address: FF4 3# (HuntGrp)# (3-10)# (ExtNo.)#
Description
Use this option to place an extension at a specific position within a hunt
group. Hunt groups can contain a maximum of 8 extension positions.
Programming
To assign an extension to a position within a hunt group ...
To clear an extension from a hunt group position ...
Related Programming
Offhook Signal: FF3 (ExtPort)# 7# (0 or 1)#
Notes
Assigning Extensions to Hunt Groups in Later CPC Versions. For CPC-
AII versions, and CPC-B Version 2.0 or higher, use FF4 3# HuntGrp# (5-
20)# (ExtNo.#) to assign extensions to hunt groups.
Hunt Group Membership Restriction. An extension can be a member of
only one hunt group. Hunt group extensions cannot belong to call coverage
groups.
Offhook Signaling for Hunt Group Members. Offhook signaling should be
disabled on extensions that are assigned as hunt group members.
Page 4-14
FF4 3# (1-8)# (3-10)# (10-69 or 100-699)#
Hunt Group No.
FF4 3# (1-8)# (3-10)# CONF ON/OFF
Hunt Group No.
DBS Manual - Revised April 2000
Position: Extension Number
3=Position 1
4=Position 2
5=Position 3
6=Position 4
7=Position 5
8=Position 6
9=Position 7
10=Position 8
Hunt Group Positions 1-8
(using address numbers 3-10)
Section 400-Programming
DBS-2.3/9.2-400