Smdr Printing Mode 1: Outbound And Inbound - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

SMDR Printing Mode 1: Outbound and Inbound

Software Version: All Versions
Address: FF1 2# 2# 6# (0 or 1)#
Description
The SMDR data sent to Serial Port CN6 can be programmed to include both
outbound and inbound calls, or it can be limited to outbound calls only. By
default, both outbound and inbound calls are recorded.
Programming
Notes
Bus Monitor Mode Interaction. If the DBS is switched to Bus Monitor
mode for troubleshooting, the SMDR mode must be reactivated to resume
SMDR output. The SMDR mode can be reactivated from any Attendant
phone by pressing ON/OFF - #93 - ON/OFF.
Page 1-60
FF1 2# 2# 6# (0 or 1)#
0=Include outbound calls only.
1=Include both inbound and outbound calls.
DBS Manual - Revised April 2000
Section 400-Programming
DBS-2.3/9.2-400