Door Phone Ring Assignments - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Door Phone Ring Assignments

Software Version: CPC-AII and CPC-B, Version 7.0 or higher
Address: FF1 2# 9# (DoorPhone)# 2# (ExtPort)# (0 or 1)#
Description
Use this address to determine which extension(s) will ring when a door phone
caller initiates a call. This applies to door phones connected to digital
extension ports only (not trunk ports).
It is possible to assign several or all extensions to ring for a door phone call.
Programming
Related Programming
Door Opener Access Code Required: FF1 2# 1# 40# (0 or 1)#
Door Phone Extensions: FF1 2# 9# (1-4)# 1# (ExtPort)#
Door Opener Access Code: FF1 2# 9# (1-4)# 3# (0000-9999)#
Door Phone Tone Type: FF1 2# 9# (1-4)# 4# (0 or 1)#
Door Phone Ring Timer: FF1 2# 9# (1-4)# 5# (0-15)#
Door Phone Ring Pattern: FF1 2# 9# (1-4)# 6# (0-5)#
Door Opener Relay Timer: FF1 2# 9# (1-4)# 7# (0-5)#
Notes
Power-Cycling Requirement. In order for changes to this parameter to take
effect, the system must be turned off, then back on.
Programming Restriction. Programming an extension to ring for a door
phone call must be performed from another extension.
Interaction With SLT Phones. An SLT phone (no speaker) can receive a
door phone call (same ring pattern as a normal intercom call).
Interaction With ML Keys. If the extension is programmed as an ML key, it
can receive a door phone call while the extension is on another call (the phone
will "buzz"). However, the door phone call will not transfer to another
Page 1-86
FF1 2# 9# (1-4)# 2# (1-72 or 1-144)# (0 or 1)#
Door Phone Number
(1-4)
DBS Manual - Revised April 2000
Section 400-Programming
Extension Port
CPC-AII: 1-72
CPC-B: 1-144
0=Do not ring.
1=Ring.
DBS-2.3/9.2-400