Table of Contents
Advertisement
Chapter 1. System Programming (FF1)
Wink Timeout Timer
Software Version: CPC-B Version 4.0 or higher
Address: FF1 8# 4# 2# 6# (0-15)#
Description
When wink-start signaling is used, the DBS waits for a wink signal from the
CO when an extension user goes off-hook. Once a wink signal is received,
the DBS sends CO dial tone to the extension.
This timer determines how long the DBS waits for a wink signal once an
extension user goes off-hook (5500 ms by default). If the DBS does not
receive a wink signal before the timer expires, the DBS disconnects the T1
channel and returns busy tone to the user.
Programming
Table 1-42. Wink Timeout Timer values
Page 1-152
FF1 8# 4# 2# 6# (0-15)#
Setting
0
150 ms
1
250 ms
2
500 ms
3
750 ms
4
1000 ms
5
1250 ms
6
1500 ms
7
1750 ms
8
2000 ms
9
2500 ms
10
3000 ms
11
3500 ms
12
4000 ms
13
4500 ms
14
5000 ms
15
5500 ms
DBS Manual - Revised April 2000
Section 400-Programming
Wink Timeout Timer setting
Default: 15 (5500 ms) (see table below)
Value
DBS-2.3/9.2-400
Advertisement
Table of Contents
