Table of Contents
Advertisement
Appendix D. CPC-AII/B 8.0 Feature Update
Programming
Operation
Notes
Page D-16
Auto-Callback is always enabled for large display phones. Use the
following to enable the MSG key for Auto-Answer Voice Message.
to enable the MSG key for Auto-Answer Voice Message...
FF3 (ExtPort)# 53# (0 or 1)#
Extension Port where
VB-44225 Large-Display
Phone is installed
To Program Voice Mailbox Access Codes into the MSG Key:
Press PROG MSG [16-digit number] HOLD
The display will reflect "Regist Data".
To Confirm a Voice Mailbox Access Code Programmed into the
Message Key..
Press CONF MSG.
The programmed access code will be displayed.
Operation With Message Waiting Indicator. The Message Waiting
Indicator on the phone's upper right corner will flash whenever a callback
message or voice message has been received.
Operation During Call States. The MSG key will work only when the
phone is idle, receiving dial tone, or in Directory Mode (via select key).
Operation If Phone Has Both a Callback Message from another
Extension and a Voice Message. Messages are accessed in a First In, First
Out order. If the callback message was received before the voice message,
then pressing the MSG key will activate Auto-Callback first. Likewise, if
the voice message was received before the callback message, pressing the
MSG key will access your Voice Mailbox.
Interaction with Tone-Calling Mode. If an Auto-Callback is placed to a
phone that is in tone-calling mode (i.e., not voice-calling), that phone must
answer or the message canceled before another message can be accessed.
DBS Manual - Revised April 2000
Section 400-Programming
0=Disable MSG key from returning
a "Message Waiting".
1=Enable MSG key for returning
a "Message Waiting".
DBS-2.3/9.2-400
Advertisement
Table of Contents
