Disa Outbound Call Id Code 2 - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

DISA Outbound Call ID Code 2

Software Version: All Versions
Address: FF1 6# 2# (0000-9999)#
Description
Once a caller has dialed in on the DISA trunk and accessed intercom dial
tone, he/she can access a trunk line by dialing #7, then the ID code set in this
address (9999 by default), then 9 or 81-86 to access the MCO trunk.
Programming
To set DISA Outbound Call ID Code 2 ...
To reset DISA Outbound ID Code 2 to default "9999" ...
Related Programming
DISA Auto Answer: FF2 (Trunk)# 11# (0 or 1)#
DISA Inbound Call ID Code: FF1 5# (0000-9999)#
DISA Outbound Call ID Code 1: FF1 6# 1# (0000-9999)#
DISA Start Time: FF2 (Trunk)# 19# (HHMM)#
DISA End Time: FF2 (Trunk)# 20# (HHMM)#
Notes
DISA Limitations --
1) A 16-second timer is set between the dialing of the DISA Outbound ID
2) The DBS supports up to two valid 4-digit DISA Outbound ID Codes, so
3) Accessing trunks via DISA can take place only on trunk (MCO) groups.
4) LCR (Least Cost Routing) is not supported on DISA trunks.
5) Trunk calling with DISA will override all TRS.
Page 1-132
FF1 6# 2# (0000-9999)#
FF1 6# 2# CONF ON/OFF
Code. If a time-out results, the DISA call is treated as a normal call.
that you can track two different groups of DISA callers on SMDR reports.
DBS Manual - Revised April 2000
Section 400-Programming
4-Digit DISA Outbound ID Code 2
(Default: 9999)
DBS-2.3/9.2-400