Chapter 1. System Programming (FF1)
PBX Flash Timer
Software Version: All Versions
Address: FF1 3# 18# (0-10)#
Description
When a DBS trunk is defined as a PBX trunk, the FLASH key can be used to
place a call on hold.
This timer determines how long the flash signal will last if the FLASH key is
pressed then immediately released (.8 seconds by default).
If the FLASH key is pressed and held down, the flash signal will last as long
as the key is pressed.
Programming
Table 1-24 PBX Flash Timer values
Related Programming
Auto Flash Redial: FF1 2# 1# 6# (0 or 1)#
Trunk Port Type: FF2 (Trunk)# 10# (1 or 2)#
Page 1-112
FF1 3# 18# (0-10)#
Setting
0
No flash
1
.2 seconds
2
.3 seconds
3
.4 seconds
4
.5 seconds
5
.6 seconds
6
.7 seconds
7
.8 seconds
8
.9 seconds
9
1 second
10
1.1 seconds
DBS Manual - Revised April 2000
Section 400-Programming
PBX Flash Timer setting
Default: 7 (.8 seconds) (see table below)
Value
DBS-2.3/9.2-400