Table of Contents
Advertisement
Appendix C. EX 1.0 Feature Update
Notes
Page C-18
You can program the *71 ring select command into an FF key. Pressing the
key toggles between "Analog Port RING" and "Key Tel RING". When the
analog port is set to ring, the FF key LED lights red. When the key
telephone is set to ring, the LED is off.
Phone Restrictions
• The Analog Adapter will work on the large-display phone only (VB-
44225).
• A dial-pulse SLT will not function on the analog port.
• Stutter Dial Tone (indicating Call-Forwarding mode, Do-Not-Disturb
mode, etc.) will not function on an SLT connected to the Analog
Adapter.
• An analog phone connected to the Analog Adapter cannot program or
access speed dials.
Incoming Calls
• You cannot program both devices to ring simultaneously.
• The "*71" code will not work if the other device is in use.
• The "*71" code will not work if FF3 (ExtPort)# 51# is set to "0".
• If set to "Analog port RING", the large-display phone will work like an
SLT/OPX (no page announcements, no voice calls from other
extensions, etc.).
• If the phone is in CF/DND (Call-Forward or Do Not Disturb), the phone
will remain in CF/DND even if the ringing device is changed via the
*71 code.
• The incoming ring pattern for the analog device is the same as for the
digital key telephone (determined by the Extension Ring Pattern in FF3
(ExtPort)# 39# (0-9)#). If this address is set to "0" (determined by CO),
the analog device will automatically default to "1 second ON, 3 seconds
OFF."
Ring Patterns Not Applicable to Analog Device. The following ring
pattern addresses will not affect the analog device:
Analog Transfer Ring Pattern FF1 2# 1# 31# (0-6)#
SLT DISA Ring Pattern
Inbound Ring Pattern
Flash Interaction. Any disconnect signal sent to the analog port must be
greater than the SLT Flash Control; otherwise the disconnect signal will be
interpreted as a flash and the call will be placed on hold.
DBS Manual - Revised April 2000
Section 400-Programming
FF1 2# 1# 34# (0 or 1)#
FF2 (Trunk)# 17# (0-9)#
DBS-2.3/9.2-400
Advertisement
Table of Contents
