Automatic Pause For Pbx Line - Panasonic DBS-2.3-400 Programming Manual

Chapter 2. Trunk Programming (FF2)

Automatic Pause for PBX Line

Software Version: All Versions
Address: FF2 (Trunk)# 13# (0 or 1)#
Description
This address determines if a pause is automatically inserted during the dialing
of a PBX access code.
If this address is enabled, the system will automatically pause after dialing the
first, second, or third digit of the PBX access code. See the PBX Access
Code(s) address (FF1 2# 3# 9-18# 1-3#) for more information.
If this address is disabled (default setting), the phone user must manually
insert a pause by pressing REDIAL. The length of the pause (whether
inserted manually by the user or automatically by the system) is determined
by the Automatic Pause Timer, which is set at address FF1 3# 12#.
Note: Before assigning the automatic pause, you must first designate the
trunk as a "PBX line" (FF2 Trunk# 10# 2#).
Programming
Related Programming
Automatic Pause Position for PBX Access Codes: FF1 2# 3# (9-18)# (1-3)#
PBX Flash Timer: FF1 3# 18# (0-10)#
Trunk Port Type: FF2 (Trunk)# 10# (1 or 2)#
Page 2-10
FF2 (1-64)# 13# (0 or 1)#
Trunk Number
DBS Manual - Revised April 2000
Section 400-Programming
0=Automatic pause is enabled.
1=Automatic pause is disabled.
DBS-2.3/9.2-400