Table of Contents
Advertisement
Chapter 1. System Programming (FF1)
Trunk Configuration
Software Version: CPC-B Versions 4.0 to 6.02
Address: Master Cabinet: FF1 8# 4# 4# 1# 1# (0 or 1)#
Slave Cabinet:
Description
Specifies the trunk combinations used in the DBS system (analog trunks only
by default).
Setting this address to "T1 and Analog trunks" tells the DBS system that T1
and analog trunks are being used in the same cabinet. (Each T1 channel uses
up one trunk port on the analog trunk card.)
Programming
Related Programming
Number of T1 Channels: FF1 8# 4# (4 or 5)# 1# 2# (0-24)#
T1 Trunk Closure: FF1 8# 7# (1 or 2)# (1-4)# (1-8)# (0 or 1)#
Trunk Circuit Type: FF2 (Trunk)# 21# (0-3)#
Notes
Power-Cycling Requirement. For changes to this parameter to take effect,
the system must be turned off, then back on.
CPC-B Versions Beginning With 6.03. The Trunk Configuration address
is no longer present -- simply use the Trunk Circuit Type address to assign
trunk ports as Loop-Start, Ground-Start, DID or T1 trunks.
Page 1-160
FF1 8# 4# 5# 1# 1# (0 or 1)#
FF1 8# 4# (4 or 5)# 1# 1# (0 or 1)#
4=Master Cabinet
5=Slave Cabinet
DBS Manual - Revised April 2000
Section 400-Programming
0=Analog trunks only.
1=T1 and Analog trunks.
DBS-2.3/9.2-400
Advertisement
Table of Contents
