Third Attendant Position - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Third Attendant Position

Software Version: CPC-AII (all versions) and CPC-B Version 2.0 or higher
Address: FF1 2# 1# 25# (11-69 or 101-699)#
Description
This address assigns an extension number as the Third Attendant position.
By default, no extension is assigned as the Third Attendant.
When all line appearances at the Primary Attendant are busy, calls will
transfer in sequence to the Second, Third, and Fourth attendants. If all line
appearances are busy on all Attendants, calls will transfer to the Attendant
Transfer Extension (if assigned).
Programming
To assign a Third Attendant position ...
To clear the Third Attendant position ...
Related Programming
Extension Number Digits: FF1 2# 1# 12# (0 or 1)##
Second Attendant Position: FF1 2# 1# 24# (11-69 or 101-699)#
Fourth Attendant Position: FF1 2# 1# 26# (11-69 or 101-699)#
Attendant Transfer Extension: FF1 2# 1# 27# (11-69 or 101-699)#
Extension Numbers (assigning to ports): FF3 (ExtPort)# 1# (ExtNo.)#
Notes
Programming Restrictions. A telephone must be plugged into the Third
Attendant port before its extension number can be programmed or cleared.
Also, use another phone to program or clear its extension number (e.g., you
can't use ext. 102's phone to program ext. 102 as the Third Attendant
position).
Limitation on Assigning the Third Attendant. The DBS system will not
allow you to assign extension 10 or 100 as the Third Attendant position. This
is the system default for the Primary Attendant phone, which cannot be
changed.
DBS-2.3/9.2-400
FF1 2# 1# 25# (11-69 or 101 to 699)#
(default: no Third Attendant assigned)
FF1 2# 1# 25# CONF ON/OFF
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Extension Number
Page 1-33