Pbx Settings; Pbx Access Code(S) - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

PBX Settings

PBX Access Code(s)

Software Version: All Versions
Address: FF1 2# 3# (1-8)# (0-999 or 0*-99*)#
Description
Use this address to program PBX Access Codes for DBS systems installed
behind a PBX or Centrex, with Toll Restriction (TRS) enabled. By default,
no PBX Access Codes are created.
Creating a PBX Access Code in this address will "activate" the PBX feature;
the DBS will recognize the first dialed digits as the PBX Access Code
(separate from the outgoing phone number being dialed). Otherwise, the
DBS will regard the Access Code as part of the outgoing phone number.
The DBS can use as many as 8 different PBX Access Codes. Each Access
Code can be one, two, or three digits long.
Programming
To program a PBX Access Code ...
To reset PBX Access Codes to default (*** no codes created) ...
Related Programming
Automatic Pause Position for PBX Access Codes: FF1 2# 3# (9-18)# (1-3)#
Trunk Port Type: FF2 (Trunk)# 10# (1 or 2)#
DBS-2.3/9.2-400
FF1 2# 3# (1-8)# (0-999 or 0*-99*)#
Access Code Number
FF1 2# 3# (1-8)# CONF ON/OFF
Access Code Number
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Access Code Required to Dial the PBX
(*=wildcard; press FF11 to enter it)
Page 1-65