Pooled Trunk Access For Groups "81-86 - Panasonic DBS-2.3-400 Programming Manual

Chapter 2. Trunk Programming (FF2)

Pooled Trunk Access for Groups "81-86"

Software Version: All Versions
Address: FF2 (Trunk)# (4-9)# (0 or 1)#
Description
Use this feature to place a trunk in a group from which trunks are
automatically chosen for outbound dialing. When you dial 81, 82, 83, 84, 85,
or 86 from an SLT or digital extension, or press an FF key that is set as a
pooled trunk key, any available trunk in the group will be accessed.
The trunk selection in a particular group is made from the highest available
trunk number to the lowest available trunk number.
Programming
Notes
Placing Trunks In More Than One Group. The same trunks may appear in
more than one pooled trunk group, including trunk group 9.
Required Hardware Setting. To use pooled trunks, Strap S1 on the CPC
card must be cut. See Section 300-Installation for instructions.
Page 2-6
FF2 (1-64)# (4-9)# (0 or 1)#
Trunk Number
DBS Manual - Revised April 2000
Pooled Trunk Group:
4=Group 81
5=Group 82
6=Group 83
7=Group 84
8=Group 85
9=Group 86
Section 400-Programming
0=The trunk is not
included.
1=The trunk is included.
DBS-2.3/9.2-400