Chapter 1. System Programming (FF1)
Odd/Even Parity
Software Version: All Versions
Address:
FF1 2# 2# 2# (0 or 1)#
Description
If parity checking for Serial Port CN6 was activated in FF1 2# 2# 1#, this
address (Odd/Even Parity) determines whether the check is based on an even
count or an odd count. By default, the parity count is even.
Programming
Notes
Checking Communications Parameters. If you later change this address
value, be sure to check all Serial Port addresses -- FF1 2# 2# 1# thru 9# -- to
make sure they are set properly.
Page 1-56
FF1 2# 2# 2# (0 or 1)#
DBS Manual - Revised April 2000
Section 400-Programming
0=Odd parity.
1=Even parity.
DBS-2.3/9.2-400