Baud Rate - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Baud Rate

Software Version: All Versions
Address: FF1 2# 2# 3# (1-4)#
Description
Use this address to set data transmission speed (baud rate) between Serial
Port CN6 and the peripheral equipment attached to it. By default, baud rate is
set at 9600 bits per second.
Programming
Notes
Checking Communications Parameters. If you later change this address
value, be sure to check all Serial Port addresses -- FF1 2# 2# 1# thru 9# -- to
make sure they are set properly.
DBS-2.3/9.2-400
FF1 2# 2# 3# (1-4)#
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
1=300 bps
2=1200 bps
3=4800 bps
4=9600 bps
Page 1-57