Stop Bit Length - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Stop Bit Length

Software Version: All Versions
Address: FF1 2# 2# 4# (1-3)#
Description
This address sets the length of the stop-bit parameter for transmitted data over
Serial Port CN6. By default, the stop bit length is set to 1 bit.
Programming
Notes
Checking Communications Parameters. If you later change this address
value, be sure to check all Serial Port addresses -- FF1 2# 2# 1# thru 9# -- to
make sure they are set properly.
Page 1-58
FF1 2# 2# 4# (1- 3)#
DBS Manual - Revised April 2000
Section 400-Programming
1=1 bit
2=1.5 bits
3=2 bits
DBS-2.3/9.2-400