Table of Contents
Advertisement
Section 400-Programming
Auto Set Relocation Code
Software Version: CPC-AII (all versions); CPC-B Version 3.1 or higher
Address: FF3 (ExtPort)# 41# (0001-9999)#
Description
You can relocate (or swap) the program settings of one phone to another. The
Auto Set Relocation Code enables you to perform the relocation.
For example, if the phone from ext.102 is unplugged and moved to an office
with a wall jack (port) that is assigned to ext.103, this feature can be used to
relocate 102's programming to 103. In order to move the programming, an
Auto Set Relocation Code must be assigned to ext.103.
Programming
To assign an Auto Set Relocation Code ...
To clear an Auto Set Relocation Code ...
Notes
Moving An Extension. The following procedure explains how to move the
program settings from extension 102 to extension 103.
DBS-2.3/9.2-400
FF3 (1-144)# 41# (0001-9999)#
Extension Port
(Destination)
FF3 (1-144)# 41# CONF ON/OFF
1.
At extension 102, pick up the handset.
2.
Press "#10."
3.
Dial extension number 103.
4.
Enter the four-digit Auto Set Relocation Code assigned to extension
103.
5.
Replace the handset. All programmed extension features, TRS, and
LCR settings from 102 will be transferred to 103. Extension 103 will
be placed out of service.
DBS Manual - Revised April 2000
Chapter 3. Extension Programming (FF3)
Auto Set Relocation Code
(0001-9999)
Page 3-49
Advertisement
Table of Contents
