Honda 2004 Odyssey Service Manual page 1175

Front and Rear Suspension
Wheel Alignment (cont'd)
Turning Angle Inspection
Use commercially-available computerized four wheel
alignment equipment to measure wheel alignment
(caster, camber, toe, and turning angle). Follow the
equipment manufacturer's instructions.
1. Turn the wheel right and left while applying the
brake, and measure the turning angle of both
wheels.
Turning angle:
Inward wheel: 41° 46' 2°
Outward wheel: 33° 28' (Reference)
2. If the turning angle is not within the specifications,
check for bent or damaged suspension
components.
18-8 18-8
Wheel Bearing End Play Inspection
1. Raise the vehicle, and support it with safety stands
in the proper locations (see page 1-15).
2. Remove the wheels, then reinstall the wheel nuts.
3. Attach the dial gauge. On the front, place the dial
gauge against the hub flange. On the rear, place the
dial gauge against the center of the hub cap.
Front/Rear:
Standard: 0 0.05 mm (0 0.002 in.)
Front:
Rear:
4. Measure the bearing end play by moving the disc
or drum inward or outward.
5. If the bearing end play measurement is more than
the standard, replace the wheel bearing.