Honda 2004 Odyssey Service Manual page 1420

Quarter Glass and Regulator Replacement
NOTE:
• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related
parts, to prevent damage.
• Put on gloves to protect your hands.
1. Remove the quarter glass and the quarter glass opener or the quarter glass lock as shown.
2. Install the quarter glass and the opener or the lock in the reverse order of the removal, and note these items:
• If necessary, replace the quarter glass seal.
• The glass and body edges should be parallel.
• Make sure the glass locks properly. If necessary adjust the quarter glass opener or quarter glass lock mount
position.
• Check for water leaks.
Fastener Locations
A : Screw, 2
5 x 0.8 mm
4 N·m
(0.4 kgf·m,
3 lbf·ft)
QUARTER GLASS
ATTACHMENT
SCREW
CAP
QUARTER SEAL
LOWER END CAP
QUARTER
GLASS
14 mm
(0.51 in.)
B Bolt, 4 (Power)
Bolt, 2 (Manual)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
ATTACHMENT PIN
B
SEAL
A
A
LOCK PIN
E-CLIP
SEAL
GLASS LOCK
QUARTER GLASS OPENER
Remove the rear pillar trim.
QUARTER GLASS
QUARTER GLASS HINGE BASE
B
GLASS SEAL
QUARTER GLASS
OPENER CONNECTOR
QUARTER GLASS LOCK
Remove the rear pillar trim.
20-55