6. Fit the inboard joint onto the driveshaft, and note
these items:
• Reinstall the inboard joint onto the driveshaft by
aligning the marks (A) on the inboard joint and
the rollers.
• Hold the driveshaft so the inboard joint points up
to prevent it from falling off.
7. Adjust the length of the driveshafts to the figure as
shown, then adjust the boots to halfway between
full compression and full extension. Make sure the
ends of the boots seat in the grooves of the
driveshaft and joint.
Left Driveshaft: 595.7 600.7 mm (23.5 23.6 in.)
Right Driveshaft: 555.8 560.8 mm (21.9 22.1 in.)
8. Fit the boot ends onto the driveshaft and the
inboard joint, then install the boot band.
A
9. Pull up the slack in the band by hand.
10. Mark a position (A) on the band 10 14 mm (0.4
0.6 in.) from the clip (B).
B
A
(cont'd)
16-11