Honda 2004 Odyssey Service Manual page 1145

Power Steering
Steering Column Removal and Installation (cont'd)
Installation
1. Install the steering column and make sure the wires
are not caught or pinched by any parts.
2. Insert the upper end of the steering joint onto the
steering shaft (A) (line up the bolt hole (B) with the
flat portion (C) on the shaft).
22 N·m
(2.2 kgf·m,
16 lbf·ft)
22 N·m
(2.2 kgf·m, 16 lbf·ft)
F
3. Slip the lower end of the steering joint onto the
pinion shaft (E) (line up the bolt hole (F) with the
groove (G) around the shaft), and loosely install the
lower joint bolt. Be sure that the lower joint bolt is
securely in the groove in the pinion shaft.
4. Pull on the steering joint to make sure that the
steering joint is fully seated. Then install the upper
joint bolt and tighten it.
5. Tighten both the upper and lower joint bolts to the
specified torque.
17-26
6. Finish the installation, and note these items:
• Make sure the wire harness is routed and
fastened properly.
• Make sure the connectors are properly connected.
• Reinstall the steering wheel (see page 17-24).
• Reconnect the battery.
– Do the PCM idle learn procedure (see page 11-
202).
– Do the power window control unit reset
procedure (see page 22-200).
– Set the clock.
– Enter the anti-theft codes for the radio and the
navigation system, then the customer's radio
station presets.
• Verify cruise control, horn, radio remote, and
turn signal switch operation.
• Check wheel alignment (see page 18-5).
A
C
B
G
E