Honda 2004 Odyssey Service Manual page 838

17. Set a dial indicator (A) on the clutch end plate (B).
A
B
18. Zero the dial indicator with the clutch end plate
lifted up to the snap ring (C).
19. Release the clutch end plate to lower the clutch end
plate, then put the special tool on the end plate (A).
B
39 N
(4 kgf, 91 lbf)
A
D
20. Press the special tool down with 39 N (4 kgf, 9 lbf)
using a force gauge, and read the dial indicator (B).
The dial indicator reads the clearance (C) between
the clutch end plate and top disc (D). Take
measurements in at least three places, and use the
average as the actual clearance.
Clutch End Plate-to-Top Disc Clearance:
Service Limit:
1st Clutch: 1.2 1.4 mm (0.047 0.055 in.)
2nd Clutch: 0.85 1.05 mm (0.033 0.041 in.)
3rd Clutch: 0.55 0.75 mm (0.022 0.030 in.)
4th Clutch: 0.55 0.75 mm (0.022 0.030 in.)
C
07ZAE-PRP0100
C
21. If the clearance is not within the service limit, select
a new clutch end plate from the following table.
NOTE: If the thickest clutch end plate is installed,
but the clearance is still over the standard, replace
the clutch discs and clutch plates as a set.
1ST and 2ND CLUTCH END PLATES
Mark Part Number
6 22551-P7T-003
7 22552-P7T-003
8 22553-P7T-003
9 22554-P7T-003
0 22555-P7T-003
1 22556-P7T-003
2 22557-P7T-003
3 22558-P7T-003
4 22559-P7T-003
3RD and 4TH CLUTCH END PLATES
Mark Part Number
1 22561-P7T-003
2 22562-P7T-003
3 22563-P7T-003
4 22564-P7T-003
5 22565-P7T-003
6 22566-P7T-003
7 22567-P7T-003
8 22568-P7T-003
9 22569-P7T-003
Thickness
2.6 mm (0.102 in.)
2.7 mm (0.106 in.)
2.8 mm (0.110 in.)
2.9 mm (0.114 in.)
3.0 mm (0.118 in.)
3.1 mm (0.122 in.)
3.2 mm (0.126 in.)
3.3 mm (0.130 in.)
3.4 mm (0.134 in.)
Thickness
2.1 mm (0.083 in.)
2.2 mm (0.087 in.)
2.3 mm (0.091 in.)
2.4 mm (0.094 in.)
2.5 mm (0.098 in.)
2.6 mm (0.102 in.)
2.7 mm (0.106 in.)
2.8 mm (0.110 in.)
2.9 mm (0.114 in.)
14-225