Honda 2004 Odyssey Service Manual page 1259

ABS Components
DTC Troubleshooting
DTC 11, 13, 15, 17:
Short to Body Ground/Short to Power)
1. Disconnect the ABS control unit connector A (22P).
2. Start the engine.
3. Measure the voltage between the appropriate
wheel sensor ( ) circuit terminal and body ground
(see table).
DTC
11 (Right-front)
13 (Left-front)
15 (Right-rear)
17 (Left-rear)
ABS CONTROL UNIT CONNECTOR A (22P)
FLW ( ) (GRN/BLU)
RLW ( ) (LT BLU)
Wire side of female terminals
Is there 2 V or more?
YES Repair short to power in the ( ) circuit wire
between the ABS control unit and the appropriate
wheel sensor.
NO Go to step 4.
19-58
Wheel Sensor (Open/
Appropriate Terminal
No. 9: FRW ( )
No. 7: FLW ( )
No. 19: RRW ( )
No. 17: RLW ( )
FRW ( ) (GRN/BLK)
RRW ( )
(GRN/YEL)
4. Check for continuity between the appropriate
wheel sensor ( ) circuit terminal and body ground
(see table).
DTC
11 (Right-front)
13 (Left-front)
15 (Right-rear)
17 (Left-rear)
ABS CONTROL UNIT CONNECTOR A (22P)
FLW ( ) (GRN/BLU)
RLW ( ) (LT BLU)
Wire side of female terminals
Is there continuity?
YES Go to step 5.
NO Go to step 6.
5. Disconnect the harness 2P connector from the
appropriate wheel sensor, then check for continuity
between the ( ) and ( ) terminals of the harness
and body ground.
Is there continuity?
YES Repair short to body ground in the ( ) or ( )
circuit wire between the ABS control unit and the
wheel sensor.
NO Replace the wheel sensor.
Appropriate Terminal
No. 9: FRW ( )
No. 7: FLW ( )
No. 19: RRW ( )
No. 17: RLW ( )
FRW ( ) (GRN/BLK)
RRW ( )
(GRN/YEL)