Secondary Shaft Clearance Inspection - Honda 2004 Odyssey Service Manual

Secondary Shaft Clearance Inspection

1. Remove the O-rings from the secondary shaft.
2. Assemble the thrust needle bearing (A), 1st gear
assembly (B), needle bearings (C), thrust needle
bearing (D), 38 x 56.5 mm splined washer (E), 32
mm cotters (F), cotter retainer (G), and snap ring (H)
on the secondary shaft (I).
3. Measure the clearance between the 38 x 56.5 mm
I
A
B
C
D
4. If the measurement is out of standard, remove the
E
F
5. Select and install a new splined washer, then
G
H
splined washer (E) and 32 mm cotters (F) with a
feeler gauge (J) in at least three places. Use the
average as the actual clearance.
Standard: 0.07 0.15 mm (0.003 0.006 in.)
J
F
E
J
splined washer, and measure its thickness.
recheck the clearance.
SPLINED WASHER, 38 x 56.5 mm
No. Part Number
1 90502-P0Z-000
2 90503-P0Z-000
3 90504-P0Z-000
4 90505-P0Z-000
5 90506-P0Z-000
6 90507-P0Z-000
B
Thickness
6.85 mm (0.270 in.)
6.90 mm (0.272 in.)
6.95 mm (0.274 in.)
7.00 mm (0.276 in.)
7.05 mm (0.278 in.)
7.10 mm (0.280 in.)
(cont'd)
14-449