Honda 2004 Odyssey Service Manual page 1086

29. Install the new gasket (A) on the transmission
housing, and install the two dowel pins (B) and new
O-rings (C) over the top of the ATF feed pipes.
6 x 1.0 mm
12 N·m
E
(1.2 kgf·m,
8.7 lbf·ft)
D
F
B
30. Install the end cover (D), and install the 13 bolts,
connector bracket (E) and harness clamp bracket (F).
31. Tighten the bolts in two or more steps in a
crisscross pattern.
32. Install the new O-ring on the input shaft (mainshaft)
speed sensor, then install it in the end cover.
33. Install the 8 x 12 mm ATF feed pipe (A) with its filter
side into the transmission housing.
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
G
C
B
A
34. Install the new gasket (B) in the mounting groove of
C
the A/T clutch pressure control solenoid valve C
body (C) properly, then install them on the
transmission housing. Do not pinch the gasket.
35. Install the ATF dipstick guide pipe (D) with the new
O-ring (E).
36. Place the new gasket (F) on the transmission
housing, then install the 8 x 18 mm ATF feed pipes
(G) with their filter side into the transmission
housing.
37. Install the new O-rings (H) over the feed pipes, and
install the 8 x 40 mm ATF feed pipe (I).
38. Install the A/T clutch pressure control solenoid
valves A and B (J) and the harness clamp bracket
(K).
C
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
A
B
G
E
F
D
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
J
K
H
I
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
(cont'd)
14-473