Honda 2004 Odyssey Service Manual page 1117

Driveline/Axle
Intermediate Shaft Reassembly (cont'd)
Special Tools Required
• Driver 07749-0010000
• Support base attachment 07LAF-SM40300
• Support base 07965-SD90100
• Oil seal driver attachment 07JAD-PH80101
• Fork seal driver, 39.2 x 49.5 x 15 mm 07947-4630100
NOTE: Refer to the Exploded View as needed during
this procedure.
1. Clean the disassembled parts with solvent, and dry
them with compressed air. Do not wash the rubber
parts with solvent.
2. Press the intermediate shaft bearing (A) into the
bearing support (B) using the special tools and a
press.
07749-0010000
07JAD-PH80101
A
3. Install, then seat the internal snap ring in the
groove of the bearing support.
16-20
PRESS
4. Press the intermediate shaft (A) into the shaft
bearing using the special tool and a press.
A
B
5. Install, then seat the external snap ring (A) in the
groove of the intermediate shaft (B).
PRESS
07947-4630100
B A