Hood Release Handle Replacement; Hood Latch Replacement - Honda 2004 Odyssey Service Manual

Openers

Hood Release Handle Replacement

1. Remove the left kick panel (see page 20-58).
2. Remove the bolts, then remove the hood release
handle.
Fastener Locations
: Bolt, 2
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
B
3. Disconnect the hood opener cable (A) from the
hood release handle (B). Take care not to kink the
cable.
4. Install the handle in the reverse order of removal,
and note there items:
• Make sure the hood opener cable is connected
properly.
• Make sure the hood opens properly.
20-154 20-154
A

Hood Latch Replacement

NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the body.
1. Remove the bolts, then remove the hood latch (A)
from the body.
Fastener Locations
: Bolt, 3
6 x 1.0 mm
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
Forward
A
2. For some '01-04 models, detach the hood latch
switch connector (A) from the body. Disconnect the
hood opener cable (B) from the hood latch (C), and
if equipped, disconnect the hood latch switch
connector. Take care not to bend the cable.
Forward
A
A
B
C
C