Honda 2004 Odyssey Service Manual page 1334

13. Check for continuity between the ABS/TCS control
unit connector B (16P) terminal No. 13 and body
ground.
ABS/TCS CONTROL UNIT CONNECTOR B (16P)
TCSR (GRN/YEL)
Wire side of female terminals
Is there continuity?
YES Repair short to body ground in the wire
between the ABS/TCS control unit and the TCS
relay.
NO Go to step 14.
14. Turn the ignition switch OFF.
15. Remove the ABS fail-safe relay. The wire colors of
the ABS fail-safe relay connector are WHT/GRN,
BRN/BLK, BLK, and YEL/GRN.
16. Connect the ABS fail-safe relay connector terminal
No. 1 and No. 2 with a jumper wire.
ABS FAIL-SAFE RELAY CONNECTOR
B (WHT/GRN)
JUMPER WIRE
SOLENOID
(BRN/BLK)
Terminal side of female terminals
17. Measure the voltage between the TCS relay
connector terminal No. 3 and body ground.
TCS RELAY CONNECTOR
Terminal side of female terminals
Is there battery voltage?
YES Go to step 18.
NO Repair open in the wire between the ABS
fail-safe relay and the TCS relay.
18. Connect the TCS relay connector No. 3 and No. 4
with a jumper wire.
NOTE: Make sure the ABS/TCS control unit
connector B (16P) is disconnected.
TCS RELAY CONNECTOR
TCSR
(GRN/YEL)
JUMPER WIRE
Terminal side of female terminals
SOLENOID
(BRN/BLK)
SOLENOID
(BRN/BLK)
(cont'd)
19-133