Honda 2004 Odyssey Service Manual page 1452

'02-04 models With Side Airbag
• SRS components are located in this area. Review the SRS component locations, '02 model (see page 23-19), '03-04
models (see page 23-20), and the precautions and procedures (see page 23-21) before performing repairs or service.
• For '03-04 models: The operation of the driver's seat position sensor must be checked after any of these actions (see
page 23-47):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail) replacement
NOTE:
• Route the seat wire harness correctly (see page 20-94).
• Make sure the bushing and pivot washer are installed correctly.
• Apply multipurpose grease to the moving portion of the seat track.
• To prevent wrinkles in the seat-back cover, stretch the material evenly over the pad.
• Replace the back panel clips with new ones.
PIVOT NUT
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
SIDE AIRBAG HARNESS
FRONT COVER
HEIGHT INNER COVER
CENTER COVER
HOOK
CLIP
(To seat cushion
cover)
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
SEAT-BACK
PIVOT WASHER
SEAT CUSHION
WIRE TIE
SEAT LINKAGE
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
SEAT CUSHION HEATER HARNESS
(For some models)
BUSHING
POWER
SEAT
SWITCH
HOOK
HEADREST
HOOK
HOOKS
SEAT-BACK
HEATER HARNESS
(For some models)
SEAT CUSHION COVER
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)
RECLINE COVER
CLIP
(To seat cushion
cover)
SWITCH
KNOBS
HEIGHT OUTER COVER
20-87