Countershaft 4Th Gear And Reverse Selector Hub Installation - Honda 2004 Odyssey Service Manual

Hide thumbs Also See for 2004 Odyssey:

Table of Contents

Shafts and Clutches

Countershaft 4th Gear and Reverse Selector Hub Installation

Special Tools Required

Driver, 40 mm I.D. 07746-0030100

1. Apply ATF to the parts.

2. Install the 1st gear on the countershaft by hand.

3. Align the shaft splines with those on 4th gear, then

press the countershaft (A) into the 4th gear with a

press. Place a shaft protector (B) between the

countershaft and press to prevent damaging the

countershaft.

4. Stop pressing the countershaft when the 4th gear

contacts the 1st gear (C).

5. Install the 31 mm cotters, 35 x 47 x 45.6 mm

distance collar, 31 mm cotters, 35 x 47 x 7.8 mm

distance collar, snap ring, needle bearing, and 5th

gear (A) on the countershaft.

6. Slide the reverse selector hub (B) over the

countershaft (C), and then press it into place with

the special tool and a press.

NOTE: Some reverse selector hubs are not press-

fitted, and can be installed without using the

special tool and a press.

07746-0030100

Table of Contents