Honda 2004 Odyssey Service Manual page 1181

Front Suspension
Knuckle/Hub Replacement (cont'd)
18. Remove the snap ring (A) and the splash guard (B)
from the knuckle (C).
A
19. Press the wheel bearing (A) out of the knuckle (B)
using the special tools and a press.
B
20. Press the wheel bearing inner race (A) from the hub
(B) using the special tool, a commercially available
bearing separator (C), and a press.
07GAF-SE00100
B
18-14
C
B
Press
07749-0010000
07746-0010500
A
Press
A
C
21. Wash the knuckle and hub thoroughly in high flash
point solvent before reassembly.
22. Press a new wheel bearing (A) into the knuckle (B)
using the old bearing (C), a steel plate (D), the
special tool, and a press. Place the wheel bearing
on the knuckle with the pack seal side facing (metal
color) toward the inside. Be careful not to damage
the sleeve of the pack seal.
D
Press
C
A
07965-SD90100
23. Install the snap ring (A) securely in the knuckle (B).
D
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
A
24. Install the splash guard (C), and tighten the screws
(D).
BLACK COLOR
METAL COLOR
INSIDE
B
07948-SB00101
B
C