Honda 2004 Odyssey Service Manual page 1024

20. Turn the ignition switch ON (II).
21. Measure the voltage between shift lock solenoid
connector terminal No. 1 and body ground.
SHIFT LOCK SOLENOID
CONNECTOR
YEL
Wire side of female terminals
Is there battery voltage?
YES Go to step 22.
NO Check for blown No. 9 (10A) fuse in the driver's
under-dash fuse/relay box. If the fuse is OK, repair
open or short in the wire between the No. 1
terminal of the shift lock solenoid connector and
the driver's under-dash fuse/relay box.
22. Connect the battery positive terminal to shift lock
solenoid connector terminal No. 1, and connect the
battery negative terminal to the terminal No. 2.
NOTE: Do not connect the terminal No. 2 to the
battery positive terminal or you will damage the
diode inside the shift lock solenoid.
SHIFT LOCK SOLENOID
CONNECTOR
Terminal side of male terminals
23. Check that the shift lock solenoid operates.
Does the shif t lock solenoid operate properly?
YES Check for a loose multiplex control unit
(driver's) connector. If necessary, substitute a
known-good multiplex control unit (driver's) and
recheck.
NO Replace the shift lock solenoid.
14-411