Honda 2004 Odyssey Service Manual page 1179

Front Suspension
Knuckle/Hub Replacement (cont'd)
Special Tools Required
• Ball joint remover, 28 mm 07MAC-SL00200
• Hub dis/assembly tool 07GAF-SE00100
• Attachment, 62 x 68 mm 07746-0010500
• Driver 07749-0010000
• Support base 07965-SD90100
• Attachment, 96 mm 07948-SB00101
1. Raise the front of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15).
2. Remove the wheel nuts (A) and front wheel (B).
3. Raise the locking tab on the spindle nut (C), then
remove the nut.
4. Remove the brake hose mounting bolt (A).
B
108 N·m
(11.0 kgf·m, 79.6 lbf·ft)
5. Remove the caliper mounting bolts (B), and hang
the caliper assembly (C) to one side. To prevent
damage to the caliper assembly or brake hose, use
a short piece of wire to hang the caliper from the
undercarriage.
18-12
B
A
108 N·m
(11.0 kgf·m,
80 lbf·ft)
C
245 N·m (25.0 kgf·m,
181 lbf·ft)
A
22 N·m
(2.2 kgf·m,
16 lbf·ft)
C
6. Remove the wheel sensor (A) from the knuckle (B).
Do not disconnect the wheel sensor connector.
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
7. Remove the 6 mm brake disc retaining screws (A).
8. Screw two 8 x 1.25 mm bolts (B) into the disc to
push it away from the hub. Turn each bolt two turns
at a time to prevent cocking the disc excessively.
A
B
B
A
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)