Honda 2004 Odyssey Service Manual page 1139

Power Steering
Pump Overhaul (cont'd)
21. Coat the new pump cover seal (A) with power
steering fluid, and install it into the groove in the
pump cover (B).
D
22. Install the outer side plate (C) over the two roll pins
(D).
23. Set the pump cam ring (A) over the two roll pins
with its ''•'' mark (B) facing down.
17-20
C
A
B
A
B
24. Assemble pump rotor (A) to the pump cover (B).
A
C
D
B
25. Set the 10 vanes (C) in the grooves in the rotor.
Make sure that the round ends (D) of the vanes are
in contact with the sliding surface of the cam ring.
26. Coat the new 15.2 mm O-ring (A) with power
steering fluid, and install it into the groove in the
side plate (B).
D
E
E
27. Install the side plate on the cam ring (C) by aligning
the roll pins set holes (D) in the side plate with the
roll pins (E).
A
B
D
C