Shift Solenoid Valve A and C Test
1. Remove the starter.
2. Disconnect the shift control solenoid valve A and C
connectors.
A
C
3. Measure the shift solenoid valve A and C resistance
at each solenoid valve connector.
Standard: 12 25
4. Replace shift solenoid valve A or C if the resistance
is out of standard.
5. If the resistance is within the standard, connect the
No. 2 terminal of the shift solenoid valve A or C
connector to the battery positive terminal, and
connect the No. 1 terminal to the battery negative
terminal. A clicking sound should be heard.
Replace shift solenoid valve A or C if no clicking
sound is heard.
Shift Solenoid Valve A and C
Replacement
NOTE: If shift solenoid valves A and C are replaced or
removed at the same time, be sure to reinstall them
correctly. The connector color of shift solenoid valve A
is black, and the connector color of shift solenoid valve
C is brown.
1. If you are replacing shift solenoid valve C, remove
the starter.
2. Remove the mounting bolt and the shift solenoid
valve A.
B
A
C
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
3. Remove the mounting bolt and shift solenoid
valve C.
4. Install a new shift solenoid valve A or C with new
O-rings (B). While installing the valves, do not
allow dust or other foreign particles to enter the
transmission.
5. Check the connectors for rust, dirt, or oil, then
reconnect them.
6. Install the starter, if removed.
B
14-359
14-359