Honda 2004 Odyssey Service Manual page 1314

6. Check the resistance between the appropriate
wheel sensor ( ) and ( ) circuit terminals (see
table).
DTC
11 (Right-front)
13 (Left-front)
15 (Right-rear)
17 (Left-rear)
ABS/TCS CONTROL UNIT CONNECTOR A (26P)
FLW ( ) (GRN/BLU)
FLW ( ) (BRN)
RLW ( )
(LT BLU)
RLW ( ) (GRY)
Wire side of female terminals
Is the resistance between 450 2,000
YES Check for loose ABS/TCS control unit
connectors. If necessary, substitute a known-good
ABS/TCS control unit, and recheck.
NO Go to step 7.
7. Disconnect the harness 2P connector from the
appropriate wheel sensor, and check the resistance
between the ( ) and ( ) terminals of the wheel
sensor.
Is the resistance between 450 2,000
YES Repair open in the ( ) or ( ) circuit wire, or
short between the ( ) circuit wire and the ( )
circuit wire between the ABS/TCS control unit and
the wheel sensor.
NO Replace the wheel sensor.
Appropriate Terminal
( ) Side ( ) Side
No. 11 : No. 10 :
FRW ( ) FRW ( )
No. 9 : No. 8 :
FLW ( ) FLW ( )
No. 23 : No. 24 :
RRW ( ) RRW ( )
No. 21 : No. 22 :
RLW ( ) RLW ( )
FRW ( ) (GRN)
FRW ( )
(GRN/BLK)
RRW ( )
(BLU/YEL)
RRW ( )
(GRN/YEL)
?
?
ABS DTC 12, 14, 16, 18:
(Electrical Noise/Intermittent Interruption)
NOTE: If the ABS indicator comes on because of
electrical noise, the indicator goes off when you test-
drive the vehicle at 19 mph (30 km/h).
1. Visually check for appropriate wheel sensor and
pulser installation (see table).
DTC Appropriate Wheel Sensor
12
14
16
18
Are they installed correctly?
YES Go to step 2.
NO Reinstall or replace the appropriate wheel
sensor or pulser.
2. Disconnect the ABS/TCS control unit connector A
(26P).
Wheel Sensor
Right-front
Left-front
Right-rear
Left-rear
(cont'd)
19-113 19-113