Honda 2004 Odyssey Service Manual page 1082

Transmission End Cover
End Cover, 3rd Gear, Idler Gear, and 3rd Clutch Installation
Special Tools Required
• Mainshaft holder
07GAB-PF50101 or 07GAB-PF50100
• Adjustable bearing puller, 25 40 mm
07736-A01000B or 07736-A01000A
1. Install the park lever (A) and park lever stop (B), on
the control shaft (C), then install the lock bolt (D)
with a new lock washer (E). Do not bend the lock
tab of the lock washer until step 28.
C
D
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
2. Lubricate the following parts with ATF:
• Splines of the countershaft, the park gear, and
the old locknut.
• Threads of the countershaft and the old locknut.
• Old conical spring washer.
3. Install the park gear (A) using the old locknut (B)
and a collar (C). Hold the park pawl (D) against the
park gear, then tighten the old locknut until the
shaft splines come out over the park gear splines.
NOTE:
• Do not use an impact wrench.
• Countershaft locknut has left-hand threads.
C
D
A
B
E
B
A
4. Remove the locknut and collar.
5. Install the thrust needle bearing (A), needle bearing
(B), 3rd gear (C), thrust needle bearing (D),
31 x 63.5 mm splined washer (E), 3rd clutch
assembly (F), and old conical spring washer (G) on
the countershaft (H). Tighten the old locknut (I) to
226 N·m (23.0 kgf·m, 166 lbf·ft).
NOTE: Use a torque wrench to tighten the locknut.
Do not use an impact wrench.
I
G
F
E
D
H
C
B
A
(cont'd)
14-469