Honda 2004 Odyssey Service Manual page 1394

5. Support the door with a floor jack (A) and a block of
wood (B), then loosen the center roller bolts (C).
B
A
6. To equalize the gaps between the door and the
body, move the door forward or backward and up
or down while keeping the center roller level. When
you're finished with this adjustment, torque the
center roller bolts.
7. Inspect the rear of the door for in or out overhang
from the rear panel; it should overhang the panel
about 0.5 mm (0.02 in.). Also inspect the position of
the striker in the latch opening while you close the
door; it should be centered up and down.
C
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
The striker should
be centered
in the latch.
(cont'd)
20-29