Road Test - Honda 2004 Odyssey Service Manual

Hide thumbs Also See for 2004 Odyssey:

Table of Contents

Automatic Transmission

Road Test

Special Tools Required

Backprobe set 07SAZ-001000A (Two required)

1. Warm up the engine to normal operating

temperature (the radiator fan comes on).

2. Apply parking brake, and block rear wheels

3. Start the engine, then shift to the D position while

depressing the brake pedal. Depress the

accelerator pedal, and release it suddenly. Make

sure that the engine should not stall.

4. Repeat the same test in the D3, 2, and 1 position.

5. Connect the HDS to the DLC (A), and go to the

PGM-FI data list; then go to step 10. If you don't

have a HDS, go to step 6.

6. Pull back the carpet, and remove the passenger's

and driver's side center lower covers to expose the

PCM (see page 11-4).

7. Remove the PCM cover from the passenger's side

under-dash to access the PCM mounting nut.

8. Remove the PCM mounting bolt, then remove the

07SAZ-001000A

9. Connect a digital multimeter (B) and the special

tools (C) to check voltage between PCM connector

terminals C27 and B20 or B22.

PCM CONNECTORS

LG2 (BRN/BLK)

LG1 (BRN/BLK)

Wire side of female terminals

TPS (RED/BLK)

Table of Contents