Honda 2004 Odyssey Service Manual page 1260

6. Check the resistance between the appropriate
wheel sensor ( ) and ( ) circuit terminals (see
table).
DTC
11 (Right-front) No. 9: FRW ( )
13 (Left-front) No. 7: FLW ( )
15 (Right-rear) No. 19: RRW ( ) No. 20: RRW ( )
17 (Left-rear) No. 17: RLW ( )
ABS CONTROL UNIT CONNECTOR A (22P)
FLW ( ) (GRN/BLU)
FLW ( ) (BRN)
RLW ( ) (LT BLU)
RLW ( ) (GRY)
Wire side of female terminals
Is the resistance between 450 2,000
YES Check for loose ABS control unit connectors.
If necessary, substitute a known-good ABS control
unit, and recheck.
NO Go to step 7.
7. Disconnect the harness 2P connector from the
appropriate wheel sensor, and check the resistance
between the ( ) and ( ) terminals of the wheel
sensor.
Is the resistance between 450 2,000
YES Repair open in the ( ) or ( ) circuit wire, or
short beween the ( ) circuit wire and the ( )
circuit wire between the ABS control unit and the
wheel sensor.
NO Replace the wheel sensor.
Appropriate Terminal
( ) Side ( ) Side
No. 8: FRW ( )
No. 6: FLW ( )
No. 18: RLW ( )
FRW ( ) (GRN)
FRW ( ) (GRN/BLK)
RRW ( ) (BLU/YEL)
RRW ( ) (GRN/YEL)
?
?
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE: If the ABS indicator comes on because of
electrical noise, the indicator goes off when you test-
drive the vehicle at 19 mph (30 km/h).
1. Visually check for appropriate wheel sensor and
pulser installation (see table).
DTC Appropriate Wheel Sensor
12
14
16
18
Are they installed correctly?
YES Go to step 2.
NO Reinstall or replace the appropriate wheel
sensor or pulser.
2. Disconnect the ABS control unit connector A (22P).
3. Measure the resistance between the appropriate
wheel sensor ( ) and ( ) circuit terminals (see
table).
DTC
12 (Right-front) No. 9: FRW ( )
14 (Left-front) No. 7: FLW ( )
16 (Right-rear) No. 19: RRW ( ) No. 20: RRW ( )
18 (Left-rear) No. 17: RLW ( )
ABS CONTROL UNIT CONNECTOR A (22P)
FLW ( ) (GRN/BLU)
FLW ( ) (BRN)
RLW ( ) (LT BLU)
RLW ( ) (GRY)
Wire side of female terminals
Is there less than 450
YES Repair a short in the wires between the
appropriate wheel sensor ( ) and ( ) circuits.
NO Go to step 4.
Right-front
Left-front
Right-rear
Left-rear
Appropriate Terminal
( ) Side ( ) Side
No. 8: FRW ( )
No. 6: FLW ( )
No. 18: RLW ( )
FRW ( ) (GRN)
FRW ( ) (GRN/BLK)
RRW ( ) (BLU/YEL)
RRW ( ) (GRN/YEL)
?
(cont'd)
19-59 19-59