Honda 2004 Odyssey Service Manual page 1457

Seats
Front Seat Disassembly/Reassembly - Manual (cont'd)
'02 model With Side Airbag
SRS components are located in this area. Review the SRS component locations (see page 23-19), and the precautions
and procedures (see page 23-21) before performing repairs or service.
NOTE:
• The passenger's seat with under seat storage tray is shown, the driver's seat is similar except that it doesn't have
the OPDS unit, center table, under seat storage tray, and navigation unit (for some models), and the passenger's
seat without under seat storage tray has no passenger subharness (see page 20-94).
• Route the seat wire harness correctly (see page 20-94).
• Make sure the bushing and pivot washer are installed correctly.
• Apply multipurpose grease to the moving portion of the seat track.
• To prevent wrinkles in the seat-back cover, stretch the material evenly over the pad.
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
COVER
RECLINE LEVER
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
90°
CONNECTING WIRE
Twist 90° to connect.
20-92
HOOKS
SIDE AIRBAG
HARNESS
WIRE TIE
SEAT CUSHION
RECLINE ADJUSTER/
OUTER SEAT TRACK
CONNECTING
WIRE
HOOK
SEAT-BACK
PASSENGER'S SEAT
SUBHARNESS
(With under seat storage tray)
UPPER END CAP
LOWER END CAP
INNER SEAT
TRACK
SEAT BELT
SWITCH HARNESS
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
SEAT RISER
HEADREST
BUSHING
PIVOT
WASHER
PIVOT NUT
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
OPDS UNIT HARNESS
LOWER END CAP
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
UPPER END CAP
CENTER COVER