Honda 2004 Odyssey Service Manual page 1463

Seats
Front Seat Linkage Disassembly/Reassembly - 8-Way Power
For '03-04 models: The operation of the driver's seat position sensor must be checked after any of these actions (see
page 23-47):
• Driver's seat position sensor replacement.
• Cover plate (front side of driver's seat slide rail) replacement.
NOTE:
• Replace the bushings with new ones.
• Apply multipurpose grease to the sliding and pivot portions.
• Check operation of the recline adjuster and slide/up-down adjuster.
SLIDE/UP-DOWN ADJUSTER
DRIVER'S SEAT
HARNESS
('03-04 models)
SEAT RISER
('03-04 models)
20-98
6 x 1.0 mm
8.5 N·m (0.87 kgf·m,
6.3 lbf·ft)
6 x 1.0 mm
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
('03-04 models)
Use a Torx T30 bit.
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)
Use a 5/8 inch socket wrench.
RECLINE ADJUSTER
UPPER END CAP
6 x 1.0 mm
8.5 N·m (0.87 kgf·m,
6.3 lbf·ft)
SEAT POSITION SENSOR
('03-04 models)
RECLINE BOOTS
6 x 1.0 mm
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
('03 model)
Use a Torx T30 bit.
LOWER END CAP
DRIVER'S
SEAT HARNESS
('99-02 models)
SEAT RISER
('99-02 models)
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)
Use a 5/8 inch socket wrench.