Honda 2004 Odyssey Service Manual page 1666

7. Check for continuity between the No. 1 terminal of
the rear mode control motor 7P connector and
body ground.
REAR MODE CONTROL MOTOR 7P CONNECTOR
BLK
Wire side of female terminals
Is there continuity?
YES Go to step 8.
NO Check for an open in the wire between the
rear mode control motor and body ground. If the
wire is OK, check for ground at G582.
8. Test the rear mode control motor (see page 21-139).
Is the rear mode control motor OK ?
YES Go to step 11.
NO Go to step 9.
9. Remove the rear mode control motor (see page 21-
139).
10. Check the rear mode control linkage and doors for
smooth movement.
Do the rear mode control linkage and doors move
smoothly?
YES Replace the rear mode control motor.
NO Repair the rear mode control linkage or
doors.
11. Remove the rear mode control motor relay, and
test it (see page 22-88).
Is the relay OK ?
YES Go to step 12.
NO Replace the rear mode control motor relay.
12. Turn the ignition switch ON (II).
13. Measure the voltage between the No. 5 terminal of
the rear mode control motor relay 5P socket and
body ground.
REAR MODE CONTROL MOTOR RELAY 5P SOCKET
BLK/YEL
Is there battery voltage?
YES Go to step 14.
NO Repair open in the wire between the No. 3
fuse in the driver's under-dash fuse/relay box and
the rear mode control motor relay.
14. Turn the ignition switch OFF.
15. Check for continuity between the No. 3 and No. 4
terminals of the rear mode control motor 7P
connector and body ground individually.
REAR MODE CONTROL MOTOR 7P CONNECTOR
GRN/WHT
Wire side of female terminals
Is there continuity?
YES Repair any short to body ground in the wire
(s) between the rear mode control motor and the
rear mode control motor relay.
NO Go to step 16.
GRN/RED
(cont'd)
21-135